![]() ![]() Neither Westlake nor any contributor can be held responsible for damages or injuries resulting from the use of the information in this document. Every effort has been made to ensure the accuracy and safety of this information. Again, this will help to ensure the drill bit will not wander.Ĭheck your state and local codes before starting any project. Using a center punch or awl, and hammer lightly tap the marked drill location to make a minor chip on the surface of the tile.Use a pencil or pen to mark the spot where you want to drill.The masking tape will prevent the drill bit from drifting or walking off the desired hole location. Put a 2”x2” piece of masking tape in an ‘X’ pattern over the area where you want to drill.(For glass, your resistance will remain the same throughout, but you shouldn’t have any problems with consistent pressure and constant lubrication.) Once the bit has drilled through the harder top layer of clay, ceramic or porcelain, it should glide through the rest of the material with ease.The oil in the putty should always touch the bit, keeping it lubricated. Center your drill bit over the mark and begin slowly drilling.It should fill to almost halfway up the putty. Place several drops of air tool oil in the middle of the ring of plumber’s putty. Smooth the putty and adhere it to the tile to form a seal.Wrap the long piece back on itself to create a ring around the mark. Knead a ball of plumber’s putty, then roll it into one long piece.Make a mark with a pen or pencil where you want to drill.If you’re drilling through tile that isn’t already installed, use MDF board behind your tile for support while you drill.A regular carbide bit should work on ceramic and porcelain, but the diamond-encrusted carbide is still recommended. Use only a diamond-encrusted carbide bit. These steps will make it easier and with less chance of ruining your material. ![]() Ceramic tiles, porcelain tiles and any glass tiles are harder to drill. This is done by using special diamond drill. The centre drill bit will pierce the tile before the hole saw, so you simply need to line up the mark on the other side.Clay tiles are usually fairly soft and easy to drill through. Installing pieces on surfaces such as porcelain and ceramic tiles, requires specific equipment and expertise. He had to drill three holes thru the porcelain tiled tub surround for the. If you are drilling into tile that has not yet been laid, turn over the tile before drilling all the way through and continue drilling from the other side. We just finished remodeling our bathroom and have all the tile installed. The tile should be kept wet at all times. Remove the masking tape and wet the tile with cold water to prevent the hole saw from overheating. Drill slowly and steadily, being sure to distribute light and even pressure over the surface of the hole saw. If you are using a hole saw, mark the tile first with the centre bit and the hole saw. Be sure to keep your drill absolutely straight when drilling. If you are drilling using a basic drill bit, drill at a slow and steady rate. The role of the tape is to prevent the drill from slipping and to protect the tile. Next, apply some masking tape over the area you want to drill and use a marker pen to mark out your drill holes. Identify where you need to drill your holes by taking measurements or by positioning the object you want to install against the wall. ![]() Never attempt to drill a tile surface in hammer mode. You will need to complete the task using a drill equipped with a variable speed drive. Usually, the tile to be drilled is already in place so there is little to no room for error. As mentioned, just about any DIYer should be up to the task of drilling through tiling to install a tap, light switch, electrical socket, spotlight, shelf and so on. ![]()
0 Comments
Leave a Reply. |